Welcome to MakerHome

We've completed our yearlong print-a-day project! New projects will be posted at www.mathgrrl.com/hacktastic.

All mathgrrl designs and associated images and files on MakerHome are licensed under the Creative Commons Attribution Non-Commercial Share Alike license. If you want to use designs, images, or files outside of the terms of this license, please email request@mathgrrl.com.

Tuesday, March 4, 2014

Day 190 - One hundred triangle-squares

In bulk printing mode again. Over the past few days we have printed 100 of the Hinged Triangle-Square models from Day 189, for a giveaway at an upcoming conference. Many more to print but a hundred is a milestone worth a picture, don't you think?


Thingiverse link: http://www.thingiverse.com/make:68301

Settings: MakerWare .3mm/low with linear fill with no support and no raft, on a Replicator 2. I've been printing six at a time, which takes about an hour. I'd do more but my build plate is warped - I know I should just order one but it is expensive! My reliability has been great, with just one lemon in the hundred I've printed so far. On one of the print runs I ran out of green filament halfway through and switched to black, as you can see in the picture.

No comments:

Post a Comment