Welcome to MakerHome




We've completed our yearlong print-a-day project!
All new material is now at Hacktastic: www.mathgrrl.com


Saturday, July 26, 2014

Day 334: Snap!

We printed ZortraX's Zortrax Buckle from Thingiverse for the sole purpose of hearing that satisfying *snap* that these types of buckles make. Can the snap be 3D-printed? Yes it can! This buckle works perfectly and makes a lovely snap. The buckle then unsnaps very nicely and seems to be holding up very well under repeated use. This is a great design!


Thingiverse link: http://www.thingiverse.com/make:89372

Settings: We printed this on a Replicator 2 with .15mm layer height, since that most closely matched the instructions for the model. To get .15mm layer height we printed on .1mm/High setting and then bumped up the layer height to .15mm.

No comments:

Post a Comment