Day 98 - Snowflake Ornaments, Part 1

For the Thingiverse/Studio 360 Ornament Challenge we remixed the snowflakes from Day 70 and Day 71 into thicker, hangable snowflake ornaments. Here is the first half:

STL file: http://www.geekhaus.com/makerhome/day98_snowflakeornaments1.stl
Tinkercad link: https://tinkercad.com/things/aZjXsjxhaZS-day-98-snowflake-ornaments-part-1
Thingiverse link: http://www.thingiverse.com/thing:195032

Settings: MakerWare .3mm/low on the Replicator 2 has each snowflake printing in 7-9 minutes.

Technical notes: Although the .stl file above has eight snowflakes at once, we recommend printing these only a few at a time. Otherwise the ones at the edges can get a little messed up, even if your build plate is very level.