Thingiverse link: http://www.thingiverse.com/make:53212
Settings: MakerWare low/.3mm prints one of these snowflakes in about 6 minutes, with two layers. They are just thick enough to be sturdy and good for hanging.
Sunday, November 10, 2013
Day 76 - Koch snowflakes
It's getting cold and I think it was supposed to snow this weekend. It didn't, so we made some more snowflakes to follow up on Day 70 and Day 71. This time gescandon's mathematically-inspired Koch snowflakes on Thingiverse.
Thingiverse link: http://www.thingiverse.com/make:53212
Settings: MakerWare low/.3mm prints one of these snowflakes in about 6 minutes, with two layers. They are just thick enough to be sturdy and good for hanging.
Thingiverse link: http://www.thingiverse.com/make:53212
Settings: MakerWare low/.3mm prints one of these snowflakes in about 6 minutes, with two layers. They are just thick enough to be sturdy and good for hanging.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment