Thingiverse link: http://www.thingiverse.com/make:77669
Settings: Printed on a Replicator 2 with MakerWare .3mm/low, upside-down so as not to require supports.
Technical notes, OpenSCAD flavor: Continuing with the same parameters as yesterday's code, today we constructed a table module. Since tables are sharper than sofas we used smaller spheres at the corners. The result is slightly nicer than just using the very sharp cube() module that we used for the legs.
/////////////////////////////////////////////////////////////
// module for making tables /////////////////////////////////
module table(depth,length,height){
// body of table
hull(){
translate(s*[0,0,0]) sphere(tiny);
translate(s*[depth,0,0]) sphere(tiny);
translate(s*[depth,length,0]) sphere(tiny);
translate(s*[0,length,0]) sphere(tiny);
translate(s*[0,length,depth/5]) sphere(tiny);
translate(s*[depth,length,depth/5]) sphere(tiny);
translate(s*[depth,0,depth/5]) sphere(tiny);
translate(s*[0,0,depth/5]) sphere(tiny);
}
// legs
translate(s*[0,0,0])
cube(s*[depth/5,depth/5,height]);
translate(s*[depth-depth/5,0,0])
cube(s*[depth/5,depth/5,height]);
translate(s*[0,length-depth/5,0])
cube(s*[depth/5,depth/5,height]);
translate(s*[depth-depth/5,length-depth/5,0])
cube(s*[depth/5,depth/5,height]);
}